Bently Nevada 330101-65-96-10-02-00

Long-case 3300 XL 8 mm probe with 6.5 in unthreaded length, 9.6 in case and 1 m standard cable.

Description & Configuration

Applications

Deep-reach radial vibration and axial position measurements on rotating machinery.

Features & Benefits

• Complete part-number identification for procurement checks.
• System-specific construction and termination details.
• Designed for compatible Bently Nevada machinery-monitoring systems.

Installation & Troubleshooting FAQ

Before installation? Confirm the exact model, mating components and required length.

Unstable signal? Inspect routing, termination, grounding and mechanical strain.

Visible damage? Remove the component from service and evaluate replacement.

Long-Case Installation Perspective

The 330101-65-96-10-02-00 is a long-case 3300 XL 8 mm proximity probe for applications that require extended mechanical reach. Its suffix identifies a 6.5-inch unthreaded length, a 9.6-inch case length and a one-metre integral cable, making dimensional confirmation especially important before ordering.

Why the Extended Geometry Matters

Long-case probes allow the sensing tip to reach a shaft target through deeper housings, brackets or stand-off arrangements. The longer body also increases the importance of straight alignment and stable support. A replacement should match the installed reach so that the probe tip can be positioned correctly without leaving excessive unsupported length.

Dimensional Verification Before Purchase

• Record the complete existing part number, including every suffix group.
• Measure the available insertion depth and confirm the required unthreaded and case lengths.
• Check thread engagement, mounting hardware, connector access and cable exit direction.
• Confirm that the probe will be used with the correct 3300 XL 8 mm extension cable and Proximitor Sensor.

Installation and Functional Check

Install the probe square to the target, support the extended body where required and prevent side loading during adjustment. After mechanical positioning, verify probe gap, channel response and alarm status under the site commissioning procedure. Keep the connector dry, clean and protected from vibration-induced movement.

FAQ

Can a shorter case be substituted? A dimensional change can alter reach and mounting security, so substitutions require an engineering review of the actual installation.

Which details speed up quotation review? Send the full suffix, quantity, machine application, installed system length and clear photos showing the existing probe and mounting arrangement.