Bently Nevada 330101-08-24-10-02-00

3300 XL 8 mm unarmored probe with 0.8 in unthreaded length, 2.4 in case and 1 m standard cable.

Description & Configuration

Applications

Radial vibration, axial position and Keyphasor phase-reference measurements.

Features & Benefits

• Complete part-number identification for procurement checks.
• System-specific construction and termination details.
• Designed for compatible Bently Nevada machinery-monitoring systems.

Installation & Troubleshooting FAQ

Before installation? Confirm the exact model, mating components and required length.

Unstable signal? Inspect routing, termination, grounding and mechanical strain.

Visible damage? Remove the component from service and evaluate replacement.

Configuration Fit and Selection Logic

The 330101-08-24-10-02-00 is a compact 3300 XL 8 mm probe configuration intended for installations that require a short unthreaded section, a defined case length and a one-metre integral cable. The complete suffix should be checked as one ordering identity because probe body geometry, case construction, cable length and connector arrangement determine whether the probe will fit the existing mounting location.

Where This Configuration Fits

Typical machinery-monitoring work includes radial vibration and shaft-position measurements where an 8 mm proximity probe is installed through a compatible bracket, probe housing or machine case. The short unthreaded tip section supports installations in which the sensing end must reach the target while the threaded body remains available for secure positioning.

Installation and Commissioning Checks

• Confirm the complete part number and the required physical reach before removing the existing probe.
• Inspect the mounting thread, target surface and cable route for damage, contamination or mechanical interference.
• Route the integral cable without sharp bends, crushing or unsupported tension near the probe body.
• Connect only to the compatible 3300 XL 8 mm extension cable and Proximitor Sensor combination.
• Verify gap voltage and monitored response according to the machinery protection system procedure before returning the channel to service.

Ordering Review

For a quotation, provide the full model, quantity, installed system length and any available photos of the existing probe label and connector. This allows the suffix, mounting geometry and system compatibility to be reviewed before dispatch.

FAQ

Can only the probe be replaced? A probe can be replaced within a compatible system, but the full probe, extension cable and Proximitor Sensor combination must remain electrically matched.

What should be checked first during troubleshooting? Inspect connector cleanliness, cable condition, mounting security, probe gap and the associated channel wiring before changing the probe position.