This armored proximity probe is ideal for radial vibration, axial position, and Keyphasor measurements on fluid-film bearing machines including centrifugal air compressors, refrigeration compressors, and process gas compressors where deeper probe case penetration, limited side-view clearance, or harsh environmental conditions require robust mechanical protection and reliable signal transmission.

Ordering Information

Installation & Troubleshooting FAQ

Q1: What is the recommended gap parameter and target output voltage for this metric NSv probe setup?
A: For a standard Bently Nevada 3300 XL NSv system calibration loop, set the physical initial gap to exactly 1.0 mm (40 mils) relative to the target face. This depth selection matches the center position of its narrow 1.5 mm (60 mils) linear operating window. Slowly rotate the probe body inside its M10x1 tapped casing until your digital multimeter tracking across the Proximitor output terminal drops onto the corresponding baseline grid voltage before locking the hex nut.

Q2: My sensor reports massive signal tracking errors when installed near a tight step or shaft shoulder. What is the cause?
A: This problem indicates a localized side-effect or cross-talk looping issue caused by inadequate physical housing clearance. Although this thin-beam NSv model handles restricted counterbores better than standard 8mm loops, an absolute minimum counterbore spacing diameter of 13 mm (0.5 in) must be preserved around the active TipLoc face. If surrounding metal parts break this spacing rule, the probe fields interact with the casing walls, distorting your straight-line accuracy curves.

Q3: How much thread depth can I safely utilize without damaging the armored case during a tight installation run?
A: For this M10x1 metric thread pattern assembly, your field installation depth must be strictly limited to a maximum thread engagement length of 15 mm (0.563 in). This standard matches the structural engineering limit of 1.5 times the nominal thread diameter. Driving the threads past this threshold creates high mechanical friction that will bind your housing assembly, warping the casing and voiding your factory replacement warranty coverage.

Accessories