The 130539-20 is a Bently Nevada high-performance accelerometer interconnect cable featuring an integrated 3-socket plug with a fluorosilicone elastomer boot and a 20-foot length. Fully compatible with 330400 and 330425 acceleration transducers, this heavy-duty shielded twisted-pair unit works seamlessly to deliver low-noise vibration signal transmission and stable industrial network communication in demanding machinery environments.
Environmental Strength
Cable Type: 3-conductor shielded cable for reliable signal transmission.
Wire Gauge: 18 AWG (1.0 mm²) for robust electrical performance.
Termination: 3-socket plug with fluorosilicone elastomer boot at one end, terminal lugs at the other.
Length: 20-foot cable for flexible installation options.
Temperature Rating: Suitable for harsh environments with fluorosilicone boot protection.
Compatibility: Designed for use with accelerometers in critical machinery monitoring applications.
Installation & Troubleshooting
- Sensor-Side Mechanical Coupling: Align the internal keyways of the 3-socket MIL connector plug with the pin layout on the accelerometer header. Hand-tighten the outer coupling sleeve onto the 316L stainless steel receptacle until it is firmly seated.
- Elastomer Boot Deployment: Fully slide the integrated fluorosilicone elastomer boot over the completed sensor-to-cable junction connection. This specialized boot establishes a tight mechanical barrier that blocks lube oil mist, wet moisture, and ambient contaminants from degrading the internal electrical pin contacts.
- Conduit Routing and Strain Relief: Route the 20-foot cable run through protective rigid or flexible industrial conduits, maintaining a clean drop loop near the sensor casing. Secure the terminal-lug end inside local junction enclosures or monitor panel strip terminals, ensuring the outer shield wire is tied cleanly to a single system ground layout.
Ordering Information Table
|
Model Number Component |
Option Code |
Description |
|
Base Model |
130539 |
3-conductor shielded 18 AWG cable with 3-socket plug and fluorosilicone boot |
|
A: Cable Length Option |
20 |
20 feet (approximately 6.10 meters) standard length |
FAQ
Q1: What is the cable type of the 130539-20?
A1: It is a 3-conductor shielded cable with 18 AWG (1.0 mm²) wire.
Q2: What are the termination options for this cable?
A2: It features a 3-socket plug with fluorosilicone elastomer boot at one end and terminal lugs at the other.
Q3: What length options are available for the 130539-20?
A3: It is available from a minimum of 2.0 feet (0.6 m) to a maximum of 99 feet (30 m), with the 130539-20 being a 20-foot configuration.
Q4: What is the purpose of the fluorosilicone elastomer boot?
A4: It provides environmental protection for the connection in harsh industrial conditions.
Q5: Is this cable compatible with Bently Nevada accelerometers?
A5: Yes, it is designed for use with accelerometers in critical machinery monitoring applications.
Accessories
| 127088 | 330400 and 330425 Accelerometer User Guide |
| 00531080 | Mating connector for 330400 and 330425 Accelerometers. |
| 37439-01 |
For use with serial numbers NOT preceded with the letter “G”. Mounting Base, ¼-28 to ¼-28. Reduces base strain sensitivity. |
| 37439-02 |
For use with serial numbers NOT preceded with the letter “G”. Mounting Base, M8X1 to M8X1. Reduces base strain sensitivity |
| 43217 | Accelerometer Mounting Kit used with extension part number 108576-01 and O-ring part number 04290422 to allow room for the 330400 or 330425 accelerometer. (See separate datasheet, document 141630.) |
For the quick assistance message us on WhatsApp at 
